ADAS calibration system for heavy transport ACS Autocom TRUCKS

Mobile calibration stand with reference targets designed to meet OE measurement requirements for trucks, buses and vans.
A safe solution that complies with manufacturers' calibration procedures.
Mobility and flexibility – fast transport and short set-up times.
Easy to use and simple workflow.
Wide coverage of brands.
Increased workshop competence and the possibility of providing additional services.
Generation of additional income and stronger customer loyalty.
Duplex calibration targets – one target can be used for two different brands.
After calibration, the possibility to print a report for the customer as proof of the work carried out.

Mobile ADAS calibration stand for trucks, buses and vans x 1
Universal target holder x 1
Double-sided calibration targets x 1 set
Targets for Volvo and Renault x 1
Targets for MAN, Iveco and Scania x 1
TFC 1 / TFC 2 targets x 1
TFC 5 / TFC 6 targets x 1

TFC 1 / TFC 2 – Front: Volkswagen (Audi, Cupra, Seat, Škoda), Rear: Mercedes (Volvo, Polestar) – used with universal bracket.
TFC 5 / TFC 6 – Front: Fiat (Hyundai, Jeep, KIA), Rear: Alfa Romeo – used with universal bracket.

Operating principle:

• During calibration, the stand is positioned in front of or behind the vehicle according to the measurements specified by the OE. The calibration function of the specific ADAS system is activated via the Autocom TRUCKS diagnostic software. The camera or radar reads the geometric and graphic representation of the target and the control unit processes the data and checks compliance with the tolerances. If deviations are detected, the system generates a DTC error code and a warning is activated on the vehicle's dashboard. After a successful calibration, the errors are corrected and the system confirms correct operation.